Underfloor electric Screed Floor Heating Kit

Underfloor electric Screed Floor Heating Kit is in the category Electric Underfloor Heating

Underfloor electric Screed Floor Heating Kit

The complete electric underfloor heating system for new concrete screeds.

Ecoflex In-screed underfloor heating cables have a rating of 15W/linear metre and are an economical solution for new screed floor constructions. The first step is to determine the number of W/m2 that you require for your installation. This could be provided by calculating the heat losses from the room you intend to heat. This figure will depend on the standard of insulation in the building.

Installation
Before Commencing, the entire sub-floor should be swept clean and be free from any sharp objects. If laying onto foil backed insulation ensure the ara is dust free to enable a good fix.
It is good practice to plan your installation using a sketch marking your laying pattern and planning the postions for the floor sensor, the connection box and thermostat.
Attatch the eco-fix band to the sub-floor or insulation using fixing nails or high impact adhesive tape. The Eco-fix bands should be spread evenly across the floor at intervals of 750mm. A 75mm border should be left around the perimeter of the room. Do not remove the cable from the drum before laying as it will twist and make the installation difficult.

The heating cables (orange cables) must not touch each other and should never cross. The heating cable must not be cut or shortened and the joint between the cold tail and the heating cable must not be bent or put under strain.

The floor sensor for the thermostat should be positioned between 2 heating cables approximately 500mm from the wall. The black flexible conduit provided should always be used to install the floor sensor probe. Once laid the heating cable should be covered with a minimum of 50mm sand and cement screed.

Before and after covering the heating cable with screed the cable resistance should be checked against the label value. Avoid traffic over the areas until the cable is completely protected. The screed should be allowed to dry completely before turning on the system. Please check screed manufacturers instructions.

A fully qualified electrician must now make the final connections to the mains supply and install the thermostat. The thermostat should be installed in the room to be heated. For bathrooms the thermostat will be a floor sensing only model and must be placed outside the room but as close to the installation as possible. Finally the electrician should check for continuity of the floor sensor and retest the resistance of the cable. A further insulation test should be carried out in accordance with IEE regulations.

The installation should be protected by a 30mA RCD for safe operation.
In-screed cable - The complete underfloor heating system for new concrete screeds, or for use directly below thick stone flooring.
kit includes:
-6mm twin conductor heating cable 20w/metre
-Digital thermostat with built in timer
-Floor probe temperature sensor
-Cable fixing strip

Related Media

• Product Catalogue (10.75 MB)
• Junckers Underfloor Heating (107 KB)

---

You might also be interested in these products

• Depron Wood Flooring Insulation Boards 5mm thick - Depron Insulation boards - 5mm thick insulation for wood floors
• Damp Proof Membrane Dpm 12sqm Pack - Moisture Resistant Lining - comes in 12m² pack
• Electric UnderFloor Heating Cable Mat System 160W and 200W - Ecofloor Under-Floor tile/stone heating mats, are a combination of self adhesive mesh with a heating cable pre-attached .The mat design enables fast installation and even heat distribution across the whole floor.
  
  For Under Tile / Stone Floors
  Ecofloor electric underfloor heating mats are 500mm wide and available in different lengths. They are suitable for kitchens, bathrooms and conservatories, easy to install and come with a 10 year manufacturers warranty.
• Electric Underfloor Wood Floor Carbon Heating Mats - EcoFilm underfloor heating is a flexible heating element it is the ideal solution for providing an economic electric underfloor heating solution for
  Laminate, Timber floating floors, Carpet, Luxury Vinyl floor coverings
  The product is ultra thin,robust and is used as a dry lay system to heat under the following floor coverings.
• Flexel Under Floor Thermostat - Flexel electric underfloor heating thermostat is one of the most energy efficient on the market, it can handle a 16amp load, yet is incredibly easy to use with full 7-day 24 hour timer.
• Ever Build flow set 690 - Ever Build flow set 690

Customer Testimonials

"Product as promised, works well" received from our Online Store.

Solid Wood Flooring

• Oak prefinished
• Oak unfinished
• Walnut flooring
• Parquet flooring
• Ash flooring
• Wenge flooring

Engineered Wood Flooring

• Engineered oak prefinished
• Engineered oak unfinished
• Engineered beech
• Engineered walnut
• Engineered Wenge

Flooring Accessories

• Adhesives
• Solid oak skirting
• Underlays
• Floor cleaning
• Underfloor Heating
• Fitting accessories

Laminate Flooring

• Kronostep laminate flooring
• Quickstep laminate flooring
• Stainless Steel flooring
• Aqua Step waterproof

Wood Doors

• External oak doors
• External wood doors
• Internal oak doors
• Internal wood doors
• Internal walnut doors
• TruFold doors

Flooring Oils & Lacquers

• Bona oils and lacquers
• Osmo oils and lacquers
• Saicos oils and lacquers
• Woca oils and lacquers

Vinyl Flooring

• Karndean Vinyl flooring

Carpets and Rugs

• Kersaint Cobb carpets
• Rugs

Other Flooring

• Floor tiles
• Cork floor tiles
• Creative floor collection

For any queries please email sales@realoakfloors.co.uk Website Designed and Maintained by Foxy Dezine
Real Oak Ltd, 234 Meanwood Road, Off Buslingthrope Green, Leeds, West Yorkshire, LS7 2HG | Tel: 0844 848 6840

2012 © copyright Real Oak Ltd no reproduction without permission, thanks!